4X Quick-Cure™

SILICONE  MOLD  RUBBER

GENERAL PURPOSE-FAST CURE

ABOUT 4X QUICK-CURE™

4X QUICK-CURE™ Silicone Mold Rubber is an economical, medium to firm rubber with extremely high tear strength and very rapid cure. It is intended to be used for all applications. Detail replication is excellent. Perfect for platinum applications due to very high pattern finish.

You can have a mold ready to inject in 30 minutes if you keep your vulcanizer preheated.

RAPID CURE:

1)  Using scissors, cut enough rubber to fill the mold frame to about 1/2 to 2/3 full.

2)  Push model into rubber to proper position and then cover over with additional rubber. Work into place, being sure to over pack slightly.

3)  Place mold frame in vulcanizer, pre-heated to  350ºF (177ºC).

4)  Vulcanize 7 minutes per 1/4” (6.35mm) of thickness. A 1/2”  frame requires      14 minutes.

5)  Rapid cool in water and cut.

Release agent is not required.

Shrink rate is 1.8% (rubber only)